Thought I'd post this here to see if someone can point out what am I missing from a setup.Last weekend I attempted a site install for a client of a USG + AC-Lite AP on Vodafone Fibre. These devices were to be adopted by a cloud controller I have running on Digital Ocean (I have the same setup at home without an issue on Bigpipe).After messing about with the CLI on the USG to connect it to VLAN10 on the WAN1 port, I could then adopt and provision the devices (the AP is connected to LAN1 port on USG). But then, after about 10 minutes, all network connectivity stops. No error message I could see in the console, nothing weird. It simply... stops.I brought all the gear back home, set up VLAN10 tag on a switch port on my bench and had both devices running for about 36 hours in the same way they would at the site. No failures.Folks with USGs on Vodafone Fibre: did you have to do anything specific to your USG to make it work? Is your controller local or remote to the site? PS: I'm attempting another install today (Sat-26) in a few hours.
↧